PGSA2Z TTP223B Capacitive Touch Switch Module Touch Sensor Switch Digital Capacitive Touch Sensor Switch DC 2~5.5V

  • This is the “momentary” variety of the touch sensor – touch and it turns on, release and it turns off
  • Positive and negative can be used as a touch surface, can replace the traditional touch button
  • Four M2 screws positioning holes for easy installation. Module can be installed in such as surface plastic, glass of non-metallic materials
  • In addition to the thin paper ( non-metallic ) covering the surface of the module , as long as the correct location of the touch, you can make hidden in the walls, desktops and other parts of buttons
  • The module is based on a touch-sensing IC (TTP223B) capacitive touch switch module. In the normal state, the module output low, low power consumption; When a finger touches the corresponding position, the module output high, if not touched for 12 seconds, switch to low-power mode
  • If you have any quarry regarding this product please contact us

300.00

1 in stock

Compare
Share

Product Description

SPECIFICATION

  • Power supply voltage VCC: 2.0–5.5 V(Typical 3V)
  • Output high VOH: 0.8VCC
  • Output low VOL: 0.3VCC
  • Output Pin Sink Current (@ VCC = 3V, VOL = 0.6V): 8mA
  • Output pin pull-up current (@ VCC = 3V, VOH = 2.4V): 4 mA
  • Response time (low power mode): 220 mS
  • Response time (touch mode): 60 mS
  • Weight: 2g

FEATURES

  • Jog type: the initial state is low level, when touched by hand, S outputs a high level and the light is on; when the hand is released, it is a low level; if you touch S again, it outputs a high level, when the hand is released, it is low Level
  • Low power consumption
  • Power supply can be 2-5.5V DC
  • Both the front and back sides can be used as the touch surface, which can replace the traditional touch button
  • 4 M2 screw positioning holes for easy installation
  • Control interface: A total of 3 pins (GND, VCC, SIG), GND is the ground, VCC is the power supply, and SIG is the digital signal output pin
  • Power indicator: green LED, it lights up when it is right
  • Touch area: The area inside the icon similar to a fingerprint, which can be triggered by a light touch of a finger
  • Positioning holes: 4 M2 screw positioning holes with a hole diameter of 2.2mm, which are easy to install and locate the modules, and realize the combination between the modules

PACKAGE INCLUDED

  • 1 x TTP223B Switch Module Digital Touch Sensor
  • Low power consumption
  • Power supply: 2-5.5V DC
  • Both sides can be used as touch surface, which can replace traditional touch keys
  • 4 M2 screw positioning holes for easy installation
  • This module can replace the traditional touch button

There are no reviews yet.

Be the first to review “PGSA2Z TTP223B Capacitive Touch Switch Module Touch Sensor Switch Digital Capacitive Touch Sensor Switch DC 2~5.5V”