PGSA2Z RFID Reader/Writer RC522 SPI S50 with RFID Card and Tag

  • This Card Reader module is based on the MF522-AN board and is delivered together with an S50 card, 6 blue key Ring and two matching pin strips
  • It is applicable for the users who need to design or manufacture the RF card terminal, for example, the development of access controls, electronic door locks or terminals for the time recording
  • It is compatible with Mifare1 S50, Mifare1 S70, MIFARE Ultralight, Mifare Pro, and MIFARE DESFire
  • This module can be directly loaded into the various reader molds. It is compatible with Arduino, Raspberry Pi and micro-controller
  • The module uses a voltage of 3.3V. It can be connected communication with user’s any CPU main-board through several lines of SPI interface; it can ensure stable and reliable work, and reader distance
  • If you have any quarry regarding this product please contact us

500.00

Out of stock

Notify Me when back in stock

Compare
Share

Product Description

DESCRIPTION

This is RFID Reader/Writer RC522 SPI S50 CARD AND KEYCHAIN which works on non-contact 13.56mhz communication, is designed by NXP as low power consumption, low cost and compact size read and write chip, is the best choice in the development of smart meters and portable hand-held devices. It uses the advanced modulation system, fully integrated at 13.56MHz with all kinds of positive non-contact communication protocols. Support 14443A compatible answer signal. DSP deal with ISO14443A frames and error correction. This module can fit directly in handheld devices for mass production. The module uses the 3.3V power supply and can communicate directly with any CPU board by connecting through the SPI protocol, which ensures reliable work, good reading distance.

SPECIFICATIONS

  • Highly integrated analog circuitry to demodulate and decode responses
  • Supports ISO/IEC 14443 A/MIFARE
  • Typical operating distance in reading/Write mode up to 50 mm
  • Supports ISO/IEC 14443 A higher transfer speed communication up to 848 kBd
  • SPI up to 10 Mbit/s
  • FIFO buffer handles 64 bytes send and receive
  • Flexible interrupt modes
  • Power-down by software mode
  • Programmable Timer
  • 2.5 V to 3.3 V power supply
  • CRC coprocessor
  • Internal self-test

PACKAGE INCLUDED

  • 1 x RFID-RC522 Reader/Write Module.
  • 1 x Standard blank RFID card.
  • 2 x A Straight & right-angle header strip.
  • 1 x Special-shaped keychain RFID tag
  • This Card Reader module is based on the MF522-AN board and is delivered together with an S50 card, 6 blue key Ring and two matching pin strips
  • It is applicable for the users who need to design or manufacture the RF card terminal, for example, the development of access controls, electronic door locks or terminals for the time recording
  • It is compatible with Mifare1 S50, Mifare1 S70, MIFARE Ultralight, Mifare Pro, and MIFARE DESFire
  • This module can be directly loaded into the various reader molds. It is compatible with Arduino, Raspberry Pi and micro-controller
  • The module uses a voltage of 3.3V. It can be connected communication with user's any CPU main-board through several lines of SPI interface; it can ensure stable and reliable work, and reader distance

There are no reviews yet.

Be the first to review “PGSA2Z RFID Reader/Writer RC522 SPI S50 with RFID Card and Tag”